Safety Instructions; Foreseeable Misuse, Residual Risks; Instructions For Transport - hawa H390 Notice De Montage Et D'utilisation

3. Safety Instructions

The instructions on foreseeable misuse and residual risks as well as the special instructions and technical data specified on pages 9 to 12 of these
instructions must be observed under all circumstances to reduce danger to life and limb as much as possible.
Please take note of the standards and regulations applicable to your low-voltage switchgear and control-gear assembly.
For any transport including moving to the installation site and unpacking as well as when completing the interior or any (later) work, take suitable safety
measures to secure the product against tipping, ideally by screwing it into the floor and additionally fixing it with straps or similar, if necessary.
The instructions for accessories must also be observed.
Torque specifications must be adhered to.
To maintain the protection class (IP) specified, all openings in the cabinet must be properly closed using devices of at least the same protection class.
Secure fitted mounting plates, swing frames and other interior fittings for transport.
The design features include equipotential bonding for the door(s), the top panel and the cable gland plates at the bottom. As an additional equipotential
bonding measure adapted to the application, these parts are fitted with ground studs or drill holes / threaded holes. You will find the mounting hardware for
grounding on our website by typing in the order number 3080-9036-03-90, as well as matching cables or straps under:
https://www.haewa.de/loesungen-produkte/schraenke/zubehoer-universal-innen/erdung-emv.html.
Ensure that the ambient temperatures at the installation site do not fall below -25 °C or exceed +40 °C, that there is no coarse dirt and excessive moisture
and that the product stands level.
Make sure that the doors are fully closed (see Instructions for Installation).
The maximum static loads as specified on page 12 must not be exceeded.
Note:
Cabinets in stainless steel design are suitable for outdoor installation if pressure compensation is assured (to be provided by customer) and water is
prevented from accumulating at the seals.

4. Foreseeable Misuse, Residual Risks

Foreseeable misuse:
• The load is not secured against falling, tipping over when moved (transport, set-up).
• More people than necessary are present in the danger zone during transport and movement to the installation site.
• The installation site is polluted. Operating conditions and usage do not comply with the intended use.
• No alignment, wrong selection of mounting hardware, use of inappropriate tools.
• Insufficient qualification of staff.
• Visual inspections and functional tests are not carried out.
• No cleaning is effected.
• Spare parts other than original parts are used.
The residual risks remaining after a risk analysis may be as follows:
• Crushing or impacts from tipping or falling objects
• Cutting at sharp edges
• Slipping, falling on dirty, wet, slippery floors
• Electric shock.
These residual risks can be avoided by working attentively and implementing protective measures as provided by the operator.

5. Instructions for Transport

The product must be transported in an upright position – preferably on a pallet. During transport, the product must be suitably secured against tipping
over – attention must be paid to load distribution, center of gravity.
In curves, enclosures must be moved slowly, irrespective of the means of transport. A tip-over hazard exists for tall or top-heavy enclosures.
Use straps or transport belts so as to avoid point loads on the doors. There is the danger of damaging the PU seals.
Pay attention to a clean working environment to avoid slipping and / or falling.
Use appropriate protective equipment (e.g. gloves, safety shoes).
9