Accessories - hawa H390 Notice De Montage Et D'utilisation

Static loads:
Maximum load incl. weight of cabinet:
Maximum load on mounting plate:
Maximum load on doors at 120° and 180°:
Note:
a) When lifting individual cabinets with the aid of the transport lugs provided, a suitable lifting gear must be used. The transport lugs must be loaded in
compliance with DIN 580 – see Instructions for Transport! The maximum total load including the weight of the cabinet is 4,000 N.
b) If lifting with the aid of the transport lugs on the cabinet can be safely excluded, then the maximum load, including the weight of the cabinet, will
increase to 14,000 N.
In that case we recommend that the transport lugs should be exchanged for top panel bolts, order numbers 3003-9000-12-25 or
3005-9000-12-25 (stainless steel A2).
c) All specifications apply provided the load is evenly distributed on the surface or in the space.
IK protection class:
IK10
IP protection class:
H390 (sheet steel): single door: IP55 / double door: IP55
H370 (stainless steel): single door: IP56 / double door: IP55
Torque specifications
The specifications stated below have been uniquely determined for standard sheet steel cabinets with standard finish and for stainless-steel
cabinets and are deemed to be binding under optimum conditions (e.g. straight fitting of thread-forming screws).
• Top panel
Attachment to body: sheet steel: 8 Nm / stainless steel: 2 Nm
• Cable gland plates
Attachment of cable gland plate(s) according to scope of delivery or variations thereof (see Accessories) to body: sheet steel 3 Nm /
stainless steel 5 Nm – after the thread is completely formed.
• Transport lugs
Attachment of transport lugs to body: min. 15 Nm – max. 35 Nm
• Mounting plate
Set of mounting brackets for mounting plate at top and bottom support bracket (T-head bolt + nut M8): 11 Nm
Attachment of mounting plate to mounting brackets: nut M8 at the top / screw M8 at the bottom: 11 Nm
• Lock (after changing the opening direction of the door)
Attachment of bar lock (interior) and key plate (exterior) to door panel: screw (2x): 2 Nm
Attachment of lock (standard 3-mm double mandrel actuation): screw M6: 4 Nm
additionally for double overlapping door:
Attachment of cover cap to key plate: screw (2x): 2 Nm
Attachment of bar guide to door panel: 2 Nm
Attachment of retaining hook to door frame: 10 Nm
• Hinges (after changing the opening direction of the door)
Attachment of hinge bracket to body: 10 Nm
Attachment of hinge bearing to door: nut: 4 Nm, threaded bushing: finger-tight
• Tubular door frame
Attachment of corner joints: sheet steel: 8 Nm / stainless steel: 7 Nm
Attachment of square tube: sheet steel: 6 Nm / stainless steel: 7 Nm
Attachment of abutting wedge (from B = 1,000 mm): 2Nm
• Protective conductor
Attachment of grounding cable / grounding straps to ground stud: sheet steel: 9 Nm / stainless steel: 6 Nm

9. Accessories

12
see notes a) and b)
7,000 N
1,000 N