Use Of The Product; Intended Use; Hardware Overview; Personnel Qualification - hawa Concepta 25 Planification Et Montage

H A W A

Use of the product

Intended use

This furniture hardware is intended for use in protected interior rooms. Install and use in dry rooms only.

Hardware overview

Articles are identified by a five-digit number.

Personnel qualification

Installation work must be carried out by authorised persons only. Authorisation is granted to persons who:
have received training in technical installation or have acquired appropriate experience
•
have read and understood the safety regulations contained in the Assembly Instructions.
•

Assembly notes

The installer is responsible for fastening the hardware at the intended location, such as wall, ceiling, floor, cabinet
body, etc. The installer must define the quantity, dimensioning and load-bearing capacity of the fastening screws to an
extent that ensures the intended load-bearing capacity of the hardware including adequate risk excess is provided.
Furthermore, it must be ensured prior to installing the hardware that the hardware and the attached pivot sliding door
do not exceed the maximum permissible load applicable to the point of installation.
The installer must ensure that with furniture the hardware and the attached sliding door do not exceed the maximum
permissible load applicable to the point of installation. The design of the furniture must ensure it cannot fall over re-
gardless of the door position.
Climatic conditions must be taken into consideration to prevent the corrosion of fastening components.
Use adequate means to prevent any unintentional loosening of fastening screws.

Maintenance and cleaning instructions

No maintenance work is required.

Risk and residual risk

The hardware does not pose any risk or residual risk.
When using HAWA-Concepta 25/30/50 to conceal electrical appliances please pay attention to the safety notes
issued by the manufacturer (heat accumulation). If necessary, use an automatic shutoff device (e.g. Safety Box,
www.halemeier.de).

Safety instructions

The symbols for safety-relevant notices (hazard warnings) used in these installation instructions have the following
meanings:
CAUTION
NOTE
Concepta 25/30
Caution: Identifies a potential hazard of medium risk which may result in
death or (serious) physical injury.
Note: Identifies practical information and tips that enable the best possible
utilisation of machines, installations or devices.
Hawa AG 8932 Mettmenstetten
Switzerland
Möbelbeschläge
Tel. +41 44 767 91 91 Fax +41 44 767 91 78
www.hawa.ch
10