Important Safety Rules - Hendi 272602 Mode D'emploi

Connecting to a gas cylinder
• Recommend to use 9kg gas cylinder or refer to
your gas supplier for suitable gas cylinder.
• Refer to your gas supplier for instructions on the
use of your gas cylinder.
• Only change gas cylinders outdoors or in a well
ventilated area away from naked flames and any
other source of ignition.
• The gas cylinder must always be used in an up-
right position.

Important safety rules

For use outdoors or in amply ventilated areas.
An amply ventilated area must have a minimum of
25% of the surface area open.
The surface area is the sum of the walls surface.
The use of this appliance in enclosed areas can be
dangerous and is PROHIBITED.
Children and adults should be aware of the high op-
erating temperatures of areas above the post when
operating this heater. Children should be carefully
supervised when in the vicinity of the heater.
NEVER hang anything, including clothes or any
other flammable items, on this heater.
DO NOT operate this heater unless it is fully as-
sembled with its reflector in place.
Respect the minimum clearances from combus-
tible materials.
The length of the gas hose may not exceed 1,5 meters.
Maintenance
To enjoy years of outstanding performance from
your heater, make sure you perform the following
maintenance activities on a regular basis:
• Keep exterior surfaces clean.
• Use warm soapy water for cleaning. Never use
flammable or corrosive cleaning agents.
• While washing your unit, be sure to keep the area
around the burner and pilot assembly dry at all
times. If the gas control is exposed to water in
any way, DO NOT try to use it. It must be replaced.
• Airflow must be unobstructed. Keep controls,
burner and circulation air passageways clean.
Signs of possible blockage include:
• Close the heater control knob by turning fully
clockwise.
• Close the gas cylinder tap and then attach the
regulator onto the gas cylinder.
• Tighten all connections firmly and with a spanner
where appropriate. The cylinder should be locat-
ed on the cylinder base.
• Check for leaks at all joints using soapy water. If
a leak is found, tighten the joint and then re-test.
Ceiling / Overhang
1 mtr
• Gas odor with extreme yellow tipping of flame.
• Heater does NOT reach the desired temperature.
• Heater glow is excessively uneven.
• Heater makes popping noises.
• Spiders and insects can nest in burner or orifices.
This dangerous condition can damage the heater
and render it unsafe for use. Clean burner holes
by using a heavy duty pipe cleaner. Compressed
air may help clear away smaller particles.
• Carbon deposits may create a fire hazard. If any
carbon deposits develop, clean dome and engine
with warm soapy water.
1 mtr
9
EN