Hendi 272602 Mode D'emploi page 4

¨ Heater does not reach a proper temperature. A temperature less than 5ºC will cause
restricted heat flow and the appliance will not work properly.
¨ The appliance starts making popping noises during use (a slight popping noise is nor-
mal when the appliance is extinguished).
• The regulator & hose assembly must be located out of pathways where people may trip
over it or in area where the hose will not be subject to accidental damage.
• Any guard or other protective device removed for servicing the heater must be replaced
before operating the heater.
• Children and adults should be warned of the hazards of high surface temperatures and
should stay away to avoid burns or clothing ignition.
• Young children and pets should be carefully supervised when they are in the area of the
heater.
• Clothing or other flammable materials should not be hung from the appliance, or placed
on or near the appliance.
• Do not place articles on or against this appliance. Certain material or items when stored
under or near this appliance will be subjected to radiant heat and could be seriously
damaged.
• Do not use or store flammable materials near this appliance.
• Do not spray aerosols in the vicinity of this appliance while it is in operation.
• Always maintain at least 0.9m clearance from combustible materials.
• Always position the appliance on a firm level surface. An amply ventilated area must have
EN
a minimum of 25% of the surface area open. The surface area is the sum of the walls
surface.
• The injector in this appliance is not removable and the injector is only assembled by
manufacture. This appliance is forbidden to convert from one gas pressure to another
pressure.
• Do not connect the gas cylinder directly to the appliance without regulator.
Intended use
• The device is intended for professional use and
can be operated only by qualified personnel.
• The appliance is designed only for heating out-
doors or well ventilated areas. Any other use may
lead to damage to the appliance or personal in-
Part List
Assembly parts supplied:
• 5pcs bolts M5 x 12 and 5pcs washers M5 for rear panel of housing and base.
• 5pcs bolts M5 x 12 and 5pcs washers M5 for rear panel of housing and housing lid.
• 3pcs bolts M5 x 12 and 3pcs washers M5 for connection of post assembly.
• 4pcs bolts M6 x 12 and 4pcs washers M6 for the post and housing lid.
• 9pcs bolts M6 x 8, 12pcs wing nuts M6 and 12pcs washers M6 for reflector.
• 3pcs bolts M5 x 12 and 3pcs washers M5 for main burner and the post.
• 6pcs bolts M5 x 8 and 6pcs washers M5 for base stands and base.
• 2pcs bolts M8 x 12, 4pcs washers M8 and 2pcs M8 nuts for wheels assembly.
4
jury.
• Operating the appliance for any other purpose
shall be deemed a misuse of the device. The user
shall be solely liable for improper use of the de-
vice.