Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Before installation, in order to avoid damage
to the appliance, remove the grease filter.
The removal of the of the metal grease-filter
is done by pushing the special filter handle
towards the rear side of the cooker hood,
making it rotate downwards.
Using the special drilling jig,
I N S TA L L ATIO N
7
perforate the wall according to the pattern
indicated by the jig itself, being careful not to
damage water pipes or electrical wires. The
wall should be perforated using a Ø 8 mm
wall drill. Insert the proper plastic reinforce-
ments into the holes that have been created.
The hood-bearing stirrups are applied using
the screws included with the equipment.
Hook the cooker hood into the bearings,
then adjust vertically and horizontally the
position of the appliance, acting on the spe-
cial regulating metric screws.
Publicité
Chapitres
Table des Matières
