Careful and accurate maintenance guaran-
tees good functioning and long lasting per-
formance. Particular care must be taken for
the grease filter panel the removal of the
metal grease-filter is done by pushing the
special filter handle towards the rear side
of the cooker hood, making it rotate down-
wards.
The filter is inserted by inversely repeating
this operation. After 30 hours of cooker
hood functioning, the keypad
the filter saturation , by the flashing of the
speed indicators. In order to reset, please
press the timer key. The grease filter may
be washed by hand or in the dishwasher.
How often it is cleaned depends on usage,
however, generally at least once every two
months. Tepid water and a mild detergent
are recommended for cleaning the applian-
ce; the use of abrasive products should be
avoided. To clean steel appliances the use
of special products is recommended, while
carefully following the instructions shown
on the product itself. To replace the dichroic
lamp, remove the lamp by inserting a small
screwdriver (or any sharp utensil) between
the lamp and the steel and replace it with
a lamp of the same kind. The supply cord
should be replaced by qualified and authori-
zed personnel only.
M A I N TE N A NCE
will signal
10
Light Bulb Replacement
Turn blower and lights off. Make sure the
lights are cool.
If new lights do not operate, check fuses and
be sure globes and breakers are inserted
correctly.
Do not remove the entire fixture (socket) as
this is very difficult to reinstall. Gently pry the
bulb from the fixture using a soft instrument
such as a toothpick. Steel instruments will
scratch the surface.
Replace the appropriate bulb. Check par-ts
brochure or specification sheets on our web-
site. Wipe both sides of the glass whilst it is
out. Reinsert the glass blocking ring and fa-
sten it.