Technical Data; Before Starting The Equipment; General Information - EINHELL BT-SM 3100 Mode D'emploi D'origine

Anleitung_BT_SM_3100_SPK1:_
GB
Contact with the saw blade in the uncovered saw
zone.
Reaching into the running saw blade (cut
injuries).
Kick-back of workpieces and parts of workpieces.
Saw blade fracturing.
Catapulting of faulty carbide tips from the saw
blade.
Damage to hearing if essential ear-muffs are not
worn.
Harmful emissions of wood dust when the
machine is used in closed rooms.

5. Technical data

Asynchronous motor
Output 1600 W S1 / 2000 W S6 25% 10 min
Idle speed n
0
Carbide-tipped saw blade
Number of teeth
Tilting range
Mitre cuts
Sawing width at 90°
Sawing width at 45°
Sawing width at 2 x 45°
(double mitre cuts)
Weight
Operating mode S6 25%: Continuous operation with
idling (cycle time 10 minutes). To ensure that the
motor does not become excessively hot it may only
be operated for 25% of the cycle at the specified
rating and must then be allowed to idle for 75% of
the cycle.
Sound and vibration
Sound and vibration values were measured in
accordance with EN 61029.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 61029.
16
15.06.2010 11:53 Uhr
Vibration emission value a
K uncertainty = 1,5 m/s
Additional information for electric power tools
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
220-240 V~ 50 Hz
Keep the noise emissions and vibrations to a
5000 min -1
minimum.
Only use appliances which are in perfect working
ø 250 x ø 30 x 2,8 mm
order.
60
Service and clean the appliance regularly.
-45° / 0°/ +45°
Adapt your working style to suit the appliance.
0° to 45° to the left
Do not overload the appliance.
Have the appliance serviced whenever
305 x 75 mm
necessary.
210 x 75 mm
Switch the appliance off when it is not in use.
Wear protective gloves.
210 x 45 mm
Residual risks
ca. 13,5 kg
Even if you use this electric power tool in
accordance with instructions, certain residual
risks cannot be rules out. The following hazards
may arise in connection with the equipment's
construction and layout:
1. Lung damage if no suitable protective dust mask
is used.
2. Damage to hearing if no suitable ear protection is
used.
3. Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or
is not properly guided and maintained.
91,9 dB(A)

6. Before starting the equipment

3 dB

6.1 General information

104,9 dB(A)
The equipment must be set up where it can stand
3 dB
securely, i.e. it should be bolted to a workbench,
a universal base frame or similar.
All the covers and safety devices have to be
properly fitted before the machine is switched on.
It must be possible for the saw blade to run
freely.
Seite 16
= 1,892 m/s 2
h
2