Canon imageRUNNER 2202N Guide Rapide page 41

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

04
Load the paper stack into the drawer.
Even out the edges of the paper stack. Load the paper
stack against the end guide of the drawer.
When loading paper into the drawer for the first time,
set the slide guides for the paper being loaded. (See
"Adjusting a Drawer to Hold a Different Paper Size
(Drawer 1), " on p.38.)
When loading paper into the drawer, make sure that the
paper size setting of the drawer matches the size of the
paper that is being loaded. (See "Adjusting a Drawer to
Hold a Different Paper Size (Drawer 1), " on p.38.)
IMPORTANT
• Rolled or curled paper must be straightened out
prior to use.
• Make sure that the height of the paper stack does
not exceed the loading limit mark at the back of the
drawer and the corners are below the paper size
guide clips.
• Make sure that the slide guides are set correctly.
If the guides are set on a wrong position, paper
jams or dirty prints may occur, or the inside of the
machine may get dirty.
NOTE
• Each drawer holds about 250 sheets of paper
(80 g/m
2
).
• If there are instructions on the package of paper
about which side of the paper to load, follow those
instructions.
• When the paper is loaded into the drawer, the side
facing up is the one printed on.
• If problems occur, such as poor print quality or
paper jams, try turning the paper stack over, and
reload it.
• For more information on the print direction of
preprinted paper (paper which has logos or
patterns already printed on it), see e-Manual > Basic
Operations.
05
Gently push the drawer back into
the machine until it clicks into place in the
closed position.
CAUTION
When returning the drawer to its original position,
be careful not to get your fingers caught, as this may
result in personal injury.
IMPORTANT
You will not be able to make copies or prints if you
load paper that exceeds the loading limit, or if the
drawer is not completely pushed into the machine.
Always check that the drawers are in place, and that
the paper does not exceed the loading limit.
NOTE
If paper runs out during copying or printing, load
a new paper stack, and follow the instructions on
the display. The machine automatically restarts, and
produces the remaining copies or prints.
37
Loading Paper

Publicité

Table des Matières
loading

Table des Matières