dirna Bergstrom bycool green line LITE IVECO Instructions De Montage page 16

LITE
EN
Line up console (narrow part at the front (*)
7
and centre equipment so that it remains where
the original was and remove console (the
equipment will leave a distance of 130 mm
from the edge of the hatch to the centre of the
M8 studs of the front part (Y)).
Caution: It is very important to check on the
inside, that once the equipment is centred, the
condenser air inlet grilles are not inside the
seal, to prevent water from entering inside the
cabin through them.
7
Short A-B cabin.
Tighten the nuts of the mounts, through to the
8
indicated measurement between the base of
the unit and the bottom part of the support.
(*) Iveco Stralis AD cabin (short cabin): 45
mm.
(*) Iveco Stralis AT cabin (long cabin) and
AS cabin (extra long cabin): 60 mm.
*
16
*
7
Long and extra long AT - AS cabin.
8
®
Y
130 mm
*