Adjusting The Belt - BH FITNESS G-6452 Instructions De Montage Et Utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 24
then check the tension of the belt. To
tension the belt, take the 6 mm Allen
key (f) and with the machine set to 4
km/h turn screws (R & L) one turn in a
clockwise direction.
Operating
Recommended
speed
period
1~6 km
1 year
6~12 km
6 months
12~16 km
3 months

ADJUSTING THE BELT

If your unit is not seated evenly on the
four contact points, this may cause the
belt (X) to shift sideways. Rigorous
quality control adjusts and checks the
running belt. However, due to weight
differences and individual styles of
running, the belt may be prone to shift
sideways.
If the belt does shift to the left or right,
stop the machine.
BELT OFFSET TO THE RIGHT
This procedure is very important.
Follow these steps. In order to adjust
the belt, set the unit in motion at a
speed of 4 km/h. If the belt has moved
to the right, turn screw (R) on the
right-hand side of the machine a 1⁄4
turn clockwise. Note the position of the
belt, if after one minute the belt is not
completely centred then repeat the
operation. If you see that the belt has
moved too far over to the left then turn
the right screw back slightly in an
anticlockwise direction. Figure 10.
As soon as you have adjusted the belt
you can begin exercising again.
BELT OFFSET TO THE LEFT
In the event that the belt has moved to
the left, turn screw (L) on the left-hand
side of the machine a 1⁄4 turn
clockwise. Note the position of the
belt, if after one minute the belt is not
completely centred then repeat the
operation. If you see that the belt has
moved too far over to the right then
lubrication
turn the left screw back slightly in an
anticlockwise direction. Figure 10.
Important: Overtightening of the belt
can lead to a loss of speed on the
machine and even stretch the belt
itself. Bear In mind that one turn of the
right screw (R) in a clockwise direction
has the same effect on the position of
the belt as one turn of the left screw
(L) in an anticlockwise direction.
Consequently,
excessive belt movement you can use
either of the two screws in order to
avoid overtightening the belt.
OPERATING INSTRUCTIONS
FITNESS
Being fit means living life to the full.
Modern society suffers greatly from
stress. City life is basically sedentary.
There are too many calories and too
much fat in our diet. All doctors agree
that regular exercise is a good way to
control our weight, make us fitter and
help us to relax.
ADVANTAGES OF EXERCISE
Regular exercise below a certain level
for 15/20 minutes becomes aerobic.
Aerobic exercise is basically exercise
that uses oxygen. Normally, this is a
continuous exercise without pauses.
In addition to sugars and fats, the
body also needs oxygen. Regular
exercise improves the body's ability to
supply oxygen to all of the muscles
and at the same time improve lung
function, the heart's pumping capacity
and better blood circulation. In short,
20
in
the
event
of

Publicité

Table des Matières
loading

Table des Matières