Use - Heating Or Boiling Water - Unold 18705 Notice D'utilisation

maximum temperature at which the water can be kept warm is the
boiling temperature.
There is no factory preset for the temperature at which the water is
kept warm. The keep warm function is ended automatically when
the kettle is removed from the base.
Through this function you can ensure that your water also still has
the desired temperature, even if you do not use it immediately after
concluding the boiling process.

USE - HEATING OR BOILING WATER

Caution: The base of the appliance should never come into
contact with water - danger of electric shock!
Only use fresh tap water. Do not boil water that has been in the
container of the electric kettle for longer than one hour, to avoid
health hazards due to the formation of germs.
1. Remove the kettle from the base.
2. Open the lid by pressing the „Open" button.
3. Add at least enough water for one cup, (appropriate mark on
the appliance). You can fill the container with a maximum of
1.5 litres of water. Do not fill more water than up to the Max
mark, otherwise the boiling water can boil over and cause inju-
ries.
4. Close the lid by pressing lightly until it locks into place.
5. Place the kettle so it is straight on the base, to ensure that con-
tact is established with the base.
6. Plug the mains plug of the appliance into an electrical outlet
(220–240 V~, 50/60 Hz).
7. The display will be illuminated for approx. 10 seconds. The dis-
play illumination will go out if you do not press a button within
these 10 seconds.
Boiling water at 100 °C
8. The basic setting of the appliance is 100 °C.
9. Press the ON/OFF button, the water will be heated to 100 °C.
10. The display flashes three times before the boiling process starts.
Copyright UNOLD AG | www.unold.de
23