LENCO LS-410 Manuel De L'utilisateur page 4

9. Do not use this device when condensation may occur. When the
unit is used in a warm wet room with damp, water droplets or
condensation may occur inside the unit and the unit may not
function properly; let the unit stand in power OFF for 1 or 2 hours
before turning on the power: the unit should be dry before
getting any power.
10. Although this device is manufactured with the utmost care and
checked several times before leaving the factory, it is still
possible that problems may occur, as with all electrical
appliances. If you notice smoke, an excessive build-up of heat or
any other unexpected phenomena, you should disconnect the
plug from the main power socket immediately.
11. This device must operate on a power source as specified on the
specification label. If you are not sure of the type of power supply
used in your home, consult your dealer or local power company.
12. Keep away from animals. Some animals enjoy biting on power
cords.
13. To clean the device, use a soft dry cloth. Do not use solvents or
petrol based fluids.
To remove severe stains, you may use a damp cloth with dilute
detergent.
14. The supplier is not responsible for damage or lost data caused by
malfunction, misuse, modification of the device or battery
replacement.
15. Do not interrupt the connection when the device is formatting or
transferring files. Otherwise, data may be corrupted or lost.
16. If the unit has USB playback function, the USB memory stick
should be plugged into the unit directly. Don't use an USB
extension cable because it can cause interference resulting in
failing of data.
17. The rating label has been marked on the bottom or back panel of
the device.
3