Technical Data - Zanussi ZBA14420SA Notice D'utilisation

Problem
Water flows into the refrig-
erator.
Water flows on the ground.
The temperature in the ap-
pliance is too low.
The temperature in the ap-
pliance is too high.
Replacing the bulb
If you want to replace the bulb, do these steps:
1. Break the circuit of the appliance.
2. Unscrew the lamp cover securing screw.
3. Unhook the moving part by pressing it as
shown in the figure.
4. Replace the bulb with one of the same
power and specifically designed for house-
hold appliances (the maximum power is
shown on the light bulb cover).
5. Fix the lamp cover in place.
6. Screw the lamp cover securing screw.
7. Reconnect the appliance.
8. Open the door and check if the light comes
on.

Technical data

Dimension of the recess
Rising Time
Voltage
Frequency
The technical information are situated in the rat-
ing plate on the internal left side of the appli-
ance and in the energy label.
www.zanussi.com
Possible cause
The water outlet is clogged.
Products prevent that water flows
into the water collector.
The melting water outlet does not
flow in the evaporative tray above
the compressor.
The temperature regulator is not set
correctly.
The temperature regulator is not set
correctly.
Height
Width
Depth
Clean the water outlet.
Make sure that products do not touch
the rear plate.
Attach the melting water outlet to the
evaporative tray.
Set a higher temperature.
Set a lower temperature.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
880 mm
560 mm
550 mm
12 h
230 V
50 Hz
Solution
9