Abus eyseo TVCC50010 Manuel Utilisateur page 29

CROSSHAIRS
VMD
OSD BLINK
MISC
Function
CAMERA ID
LANGUAGE
SYNC (not
selectable)
H-START: 0 – 723
Here you can set the horizontal starting point.
H-END: 1 – 724
Here you can set the horizontal ending point.
V-START: 0 – 293
Here you can set the vertical starting point.
V-END: 1 – 294
Here you can set the vertical end point.
Here you can turn on / off a cross line in order to better adjust the
camera.
CROSSHAIRS: ON / OFF
Here you can turn the function on / off.
Here you can configure the internal video motion detection. If motion is
detected the relay output (NO) is switched.
VMD: ON / OFF
Here you can turn the function on / off.
AREA: 6x8 Fields
By pressing the ENTER Button you can select fields where motion
shall be recognized. Selected fields appear in grey.
TIME: 10-60 SEC
Here you can set how long the information „MOTION" will appear in
OSD after motion detection.
SENSITIVITY: 1 - 9
Here you can set the sensitivity of the motion detection.
The lower the value, the lower the sensitivity.
VMD DISPLAY: ON /OFF
Here you turn on / off the motion detection notice. This setting will only
control the notice and not the video motion detection itself.
Here you can blend in a blinking symbol at the top right corner in order
to verify the live image.
OSD: ON / OFF
Here you can turn the function on / off.
Description
Here you can set a title for the camera.
SELECT CHARACTER
Select a name by using the characters.
POSITION: OFF / UP / DOWN
OFF: Title is not shown.
UP: Title is shown on the top picture margin.
DOWN: Title is shown on the bottom picture margin.
Here the OSD language is shown (only English available)
SYNC: OFF
Here you can synchronize by „Line-Lock".
Only for board cameras, not TVCC50010/TVCC50510 - JP2(5) has to
be used).
PHASE LEVEL: 0
Only used by „Line-Lock" in order to synchronize (0~180°).
29