Haussmann Xpert 58485001 Manuel De L'utilisateur page 19

TILTING THE TABLE ADJUSTMENT
WARNING
MAKE CERTAIN MACHINE IS DISCONNECTED
FROM POWER SOURCE.
The table can be tilted up to 45 degrees down. To tilt the
table down as shown in Figure 8, loosen table lock
handles (B) in Figure 7, and pivot table until desired angle
is established. Then tighten table locking handle.
WARNING
To avoid trapping the work or fingers between the table
and abrasive disc, the table edge (G) must be positioned
a maximmum of 1/16" from the abrasive disc shown in
Figure 8. For adjustments, see section "Adjusting Mitre
Gauge Slot Parallel with the Abrasive Disc."
Figure 8
G
18
SANDING AND END SANDING WITH
ACCESSORY MITRE GAUGE
• A 3/8" x 3/4" slot was built into the table platform for
mitre gauge applications.
• Use mitre gauge for precise straight and angled end
sanding.
Figure 9
Figure 10
H
G