Safety Rules; Specifications - Haussmann Xpert 58485001 Manuel De L'utilisateur

Safety Rules . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
Preparation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
Operation Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . 17
WARNING
Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains chemicals
known to cause cancer, birth defects or other reproductive harm.
Some examples of these chemicals are:
• Lead from lead-based paints.
• Crystalline silica from bricks and cement and other masonry products.
• Arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to
these chemicals: work in a well ventilated area and work with approved safety equipment. Always wear OSHA/NIOSH
approved, properly fitting face mask or respirator when using such tools.
WARNING
For your own safety, read all of the rules and precautions before operating tool.
WARNING
Always follow proper operating procedures as defined in this manual even if you are familiar with use of this or similar
tools. Remember that being careless for even a fraction of a second can result in severe personal injury.
Motor . . . . . . . . . . . 120V, 60 Hz, 3.5 Amps, Single Phase
Peak HP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1/2
Disc Speed . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1725 RPM
Disc Size . . . . . . . . . . . . . . . . . . . . . . . . . . . 12" (305 mm)
Table Size . . . . . . . . . . . . . . 7" x 13-1/2" (178 x 343 mm)
TABLE OF CONTENTS

SAFETY RULES

SPECIFICATIONS

13
Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20
Schematic Drawing and List . . . . . . . . . . . . . . . . . . . . . 21
Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23
Table Tilt . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0˚ to 45˚
Height . . . . . . . . . . . . . . . . . . . . . . . . . . .17-3/8" (441 mm)
Width . . . . . . . . . . . . . . . . . . . . . . . . . . .15-3/4" (400 mm)
Depth . . . . . . . . . . . . . . . . . . . . . . . . . . .17-3/8" (441 mm)
Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .31 lbs (14 kg)