Startup / Self-Test; Turn Off - Sportec 27535 Mode D'emploi

5.3

Startup / Self-test

All of the device's functions are automatically checked by a built-in microprocessor when the
device is turned on using the on / off switch on the back of the device. Then the device runs a
self-test. All the time the device is in use, the actual current at the output is automatically
measured and compared to the specified requirement. If a fault in the current is detected, the
power is switched off automatically.
•
Use the ON / OFF switch on the back of the unit
•
Immediately after the device is switched on, it automatically performs a self-test
5.4

Turn Off

•
Use the main power switch on the back of the device to turn off the device
•
Unplug the power cord
10 of 32 EN109-1730752-41