Maintenance And Inspection - Jet JSS-16A Mode D'emploi

Tooth form :
Tooth form (Fig 30) has an effect on cutting rate.
‐ Regular (A) Standard blade form with evenly spaced teeth
and zero‐degree rake angle. Offers clean cuts at slower feed
rates.
‐ Skip tooth (B) More space between teeth, for good chip
removal and fast cuts.
‐ Double tooth (C) A skip tooth with larger gaps between
tooth sets; good chip removal, fast cutting.
‐ Reverse tooth (D) Prevents underside tear‐out, leaves clean
edge.
‐ Spiral (E) Cuts on all sides without turning workpiece; good
for narrow fretwork.
‐ Crown tooth (F) Cuts on both up and down strokes; good for
clean, splinter‐free edges.
A crown tooth blade may often be turned over for a fresh set
of cutting teeth.
9. Maintenance and inspection
General notes:
Maintenance, cleaning and repair work may only be carried
out after the machine is protected against accidental starting
by pulling the mains plug.
Repair and maintenance work on the electrical system may
only be carried out by a qualified electrician.
Clean the machine regularly.
Inspect the proper function of the dust extraction daily.
All protective and safety devices must be re‐attached
Fig 13
immediately after completed cleaning, repair and maintenance
work.
Defective safety devices must be replaced immediately.
Cleaning:
Regularly clean the machine housing with a soft cloth
preferably after each use.
If the dirt does not come off use a soft cloth moistened with
soapy water.
Never use solvents such as petrol, alcohol, ammoniac water,
etc. These solvents may damage the plastic parts.
Saw blades:
Only use sharp saw blades.
Lubrication:
Lubricate the arm bearings after every 50 hours of use.
Remove the 4 bearing covers (B, Fig 14).
Apply a generous amount of light oil (SAE 20).
Replace the bearing covers.
Motor brushes:
The collector brushes are due to wear and may need
replacement.
‐ Disconnect the machine form the power source, pull mains
plug.
‐remove the brush covers.
‐Replace the collector brushes (Jet Article Number: JSS16A‐079
....2 pieces needed).
‐reattach the brush covers.
Fig 14