Zipper Maschinen ZI-HS5TN Mode D'emploi page 42

ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-HS5TN; ZI-HS7TU
Waste oils are toxic and must not be
discharged into the environment.
Contact your local authorities for
information on proper disposal.
To change oil carry out the following steps:
1. Make sure that all moving parts stand still
and that the splitter is disconnected from
the power source.
Loosen the oil drain plug with dipstick and
2.
remove it.
3. Turn the log splitter on the support leg
over a four litres capacity container and
drain the hydraulic oil off.
4. Then turn the wood splitter to the motor
side.
5. Top up with fresh hydraulic oil of
appropriate specification.
6. Make sure that the level of the refilled oil is
correct.
7. Re-insert the oil drain bolt with the dipstick
and tighten.
Make sure that the bolt is tightened to
8.
prevent oil from leaking when the log
splitter is returned to the horizontal
position.
MAINTENANCE
42