Scan Mode Operation; Using The Radio In Scan Mode - Uniden MHS75 Guide D'utilisation

Scan mode operation

You can save channels into memory and then use scan
mode to monitor those channels from lowest to highest. If the
radio detects a signal on a channel, it stays on that channel
as long as the signal is received; when the signal stops, the
radio continues scanning.
When it detects a signal, the radio stays
on the channel until you press the
Channel Up button or the signal stops.
08 10
The radio scans about
5 channels in 0.5 seconds.

Using the radio in scan mode

• To activate scan mode, press
• You must have at least two channels in memory to start a
scan.
• You cannot transmit while in scan mode.
• To save a channel into memory, select the channel, then
press the Mem button. The Mem icon shows on the display
whenever you tune to that channel.
• To remove a channel from memory, set the radio to that
channel, then press the Mem button. The Mem icon no
longer shows on the display.
• When the radio stays on a channel, press
leave that channel and resume scanning.
• To end the scan, press the
radio remains on the last scanned channel.
Uniden MHS75 Radio Owner's Manual
11 12 13 14
Scan-Dual.
Scan-Dual button again; the
Resume
scan
17
15
Channel Up to
E-9