Safety Notices; Technical Data - FLORABEST 317229 1904 Instructions D'utilisation Et Consignes De Sécurité

Mesh Garden Table
Introduction
We congratulate you on the purchase of your new
product. You have chosen a high quality product.
Familiarise yourself with the product before using it
for the first time. In addition, please carefully refer to
the operating instructions and the safety advice below.
Only use the product as instructed and only for the
indicated field of application. Keep these instructions
in a safe place. If you pass the product on to anyone
else, please ensure that you also pass on all the doc­
umentation with it.
Intended use
This product is suitable for personal use with a max.
load of 50 kg. This product is not intended for com­
mercial purposes. This product was manufactured for
private residential use.
Scope of delivery
1 x Table top
A
2 x Side frame
B
1 x Support bar
C
8 x Screw
D
8 x Nut
E
16 x Washer
F
8 x Nut cap
G
8 x Screw cap
H
1 x Wrench
I
1 x Key
J
Adjustable feet
K

Technical Data

Dimension: approx.140 x 74 x 90 cm (W x H x D)
Weight: approx. 15 kg
Max load: 50 kg
8 GB/IE

Safety Notices

AND RISK OF ACCIDENTS FOR
INFANTS AND CHILDREN! Never leave children
unsupervised with the packaging materials. The
packaging material poses a suffocation hazard.
Secure the product in extreme weather, e.g. strong
wind.
Verify the product is stable before use.
Set the product on a level, firm surface.
This product is not a toy and should only be used
under adult supervision.
Check the product for damage before using it.
Please note the maximum weight capacity of 50 kg.
Exceeding this weight limit may result in injuries
and / or property damage.
Do not sit or stand on the product.
Do not fix an umbrella to the edge of the table
under any circumstances. This could result in
injuries and / or damage to the product.
Assembly instructions
1. Connect the supporting bar
2. Put the screw , 2 washers
D
together into the hole (see fig 1) and slightly fix
them in place. Repeat this step three times.
Note: Recommend to tighten all screws
nuts after step 2. Otherwise, the hole on side
frame and the hole on table top
B
matched.
3. Connect the table top
4. Put the screw , 2 washers
D
together into the hole (see fig 2) and slightly fix
them in place. Repeat this step three times.
5. Tighten all screws and nuts by key
6. Put on all nut cap
G
cap onto the screw
H
7. Adjust the height of table by using the adjustable
feet to maximize the stability (see fig 3).
K
Cleaning and Care
Clean the product and remove stains with a damp
cloth and a mild cleaner.
DANGER TO LIFE
to the side frame
C
and 1 nut
F E
and
D
cannot be
A
to the side frame
A B
and 1 nut
F E
and wrench
J
onto the nut and all screw
E
.
D
.
B
.
.
I