Congratulations!
With your purchase you have decided on a
high-quality product. Get to know the product
before you start to use it.
Carefully read the following instruc-
tions.
Use the product only as described and only
for the given areas of application. Keep these
instructions safe. When passing the product
on to a third party, always make sure that the
documentation is included.
Scope of delivery (figure A)
1 x Tabletop (1)
1 x Folding frame (2)
2 x Balcony mounts (3)
2 x Spacers (4)
2 x Wing screws (5)
2 x Wing nuts (6)
1 x Instructions for use
Technical Data
Dimensions of tabletop:
approx. 60 x 40cm (L x W)
Maximal load capacity: approx. 20kg
Date of manufacture (month/year):
01/2018
Correct use
The article is not intended for commercial use.
The article is designed for use in the living area,
e.g. balcony, terrace, or garden. The article is
suitable for balcony parapets with a diameter of
up to 7cm.
Safety notes
Risk to life!
• Never allow children to play with the packag-
ing material unsupervised. There is a risk of
suffocation.
Risk of injury!
• Warning: Children must be supervised – risk
of falling!
• Ensure correct stability before using the arti-
cle.
• Take particular care of your fingers during
assembly and dismantling. There is a risk of
injury from crushing.
• Ensure that the locking mechanism is in place
before using the article.
• The article may only be used with adult super-
vision and may not be used as a toy.
• Inspect the article for damage or wear before
each use.
• Never sit or stand on the table.
• Do not place more than 20kg load on the
article.
• Secure the article in extreme weather condi-
tions such as strong wind. Store the article in a
protected area.
Assembly
1. Remove the packaging material and place
the tabletop (1) on the floor with the height
adjusters (1a) at the top (figure B).
2. Put the folding frame (2) U-shaped onto the
tabletop. The holes (2a) on the folding frame
must be positioned next to the holes on the
height adjuster (1a) (figure C).
3. Insert the balcony mounts (3) into the open-
ings (2b) on the folding frame.
The ends of the balcony mount must face
upwards (figure D).
Note: The balcony mounts have three holes.
The holes are used to set the height at which the
article should hang on your balcony.
4. Position the desired holes on the balcony
mounts into the folding frame so that the holes
are above one another.
5. Place a spacer (4) between the folding frame
and the height adjuster on both sides and
insert one wing screw (5) through the folding
frame, balcony mount, spacer, and height
adjuster from the outside (figure E).
6. Fix the wing screw on both sides with a wing
nut (6) and hang the fully assembled article
on your balcony.
GB
11