the backrest to the desired height.
14 FIVE POINT SAFETY HARNESS: To fasten it,
push the two waist strap buckles (with the
shoulder straps attached – arrow_a) into
the leg divider until they click into place
(arrow_b). To unfasten it, press the round
button in the centre of the buckle (arrow_c)
and pull the waist straps out (arrow_d).
15 To tighten the waist strap, pull on both sides
in the direction of the arrow (arrow_a). To
loosen it, move it in the opposite direction.
16 Before adjusting the height of the safety
harness remove the shoulder pads (fig_a). To
adjust the height, slip the belts through the
eyelet in the fabric (fig_b) and position them
in the most suitable eyelet.
17 FOLDING UP: To fold up the stroller, you must
ensure the front wheel swivels and the hood
are closed, when fastened. Place the handle
as shown in the figure (fig_a). Pull the inside
handle on the base (fig_b) and lift it (fig_c);
the handle will drop forward until the frame
is closed.
18 To close correctly, check the side hook is
inserted (fig_a). If not automatically locked,
compress the chassis slightly. When folded,
the stroller will free standing (fig_b).
19 For greater compactness, it is possible to
remove the wheels.
To remove the rear wheels: pull the pivot
outwards and remove the wheel as shown in
the figure (fig_a).
To remove the front wheels: press the tab as
shown, and remove the wheel (fig_b).
TRANSPORT: the stroller can be carried
comfortably locking the front wheels and
grasping the main handle (fig_c).
20 REMOVABLE ITEMS: to remove the hood, take
the elastic off from the buttons on the inside
of the handlebar (fig_a), detach the press
studs the sides of the chassis (fig_b), detach
the Velcro strip from the backrest (fig_c) and
remove the attachments of the hood from
their positions on the chassis (fig_d).
21 To remove the seat fabric, press in the
holes on the inside of the chassis (fig_a);
remove, from the side of the seat, the rigid
flap of the chassis fabric ((fig_b), unfasten
the elastic of the net from the side buttons
inside the handlebar (fig_c) and unfasten
the elastics from the buttons inside the
chassis (fig_d).
22 Slip the cover off the footrest from the front
(fig_a), pull the crotch strap out from below
the seat (fig_b), unhook the rubber band
from the seat's side hook (fig_c), unscrew the
waist strap (fig_d) and remove the cover from
the backrest (fig_e).
GANCIOMATIC SYSTEM
The Ganciomatic System is the quick,
practical system that allows you to fasten the
Primo Viaggio 4•35 car seat (sold separately)
onto the stroller using the Ganciomatic
hooks.
23 GANCIOMATIC HOOKS ON THE STROLLER: to
lift the stroller's Ganciomatic hooks, pull back
the fabric at the corners of the seat.
Pull the frame's side levers outwards (fig_a)
and turn the Ganciomatic hooks upwards.
_ To lower the hooks, proceed in the opposite
order.
GANCIOMATIC FASTENING
24 Book Cross + Primo Viaggio 4•35
To mount the car seat on the stroller or
chassis, you must:
_ Engage the stroller's brake;
_ Lift the stroller's Ganciomatic hooks;
_ Pull the front bar out to the second position
(fig_a).
_ Fully lower the backrest, if in place.
_ Place the car seat, facing mom, on the
Ganciomatic hooks and push it down until it
clicks into place.
_ Once the seat is mounted, lift the backrest - if
in place - to the maximum height (fig_b).
_ See the instruction manual to release the car
seat from the stroller.
SERIAL NUMBERS
25 Information about the production date can
be found on the Book Cross .
_ The product name, production date and serial
number of the chassis.
This information is required for any
complaints.
ACCESSORIES
26 BABY CUSHION: For Peg Perego high chairs
and strollers. Winter side of quilted jersey
fabric, summer side of 100% cotton (fig_a).
MOSQUITO NETTING: may be fastened to the
hood (fig_b).
RAIN COVER: can be fastened to the hood
(fig_c).
27 BORSA: a large bag with a mat to change the
baby on (fig_a).
CUP HOLDER: may be fastened to the
mushroom button on the frame (fig_b).
BOOK BOARD: Rear footrest plus two
handlebar extensions (fig_c).
28 BOOK HANDLE EXTENSIONS: Two handle
extensions (fig_a).
PARASOL: practical matching umbrella
(fig_b).
CLEANING AND MAINTENANCE
PRODUCT MAINTENANCE: protect from the
weather: water, rain, or snow; prolonged
and continuous exposure to bright sunlight
- 14 -