SCHOLTES CI 66 M W S Mode D'emploi page 36

Automatic cleaning using the
PYROLYTIC cycle
GB
During the PYROLYTIC cycle, the internal
temperature of the oven reaches 500°C. The
pyrolytic cycle is activated and burns away food
and grime residues. Dirt is literally incinerated.
Keep children away from the appliance during the
automatic cleaning cycle as surfaces may become
very hot. Particles may ignite inside the oven as a
result of the combustion process. There is no cause
for concern: this process is both normal and hazard-
free.
Before initiating the PYROLYTIC CYCLE:
• Remove large or coarse food residues from the
inside of the oven using a damp sponge. Do not
use detergents.
• Remove all accessories.
• Do not place tea towels or pot holders over the
oven handle.
• Turn the SELECTOR knob to the "0" position.
! If the oven is too hot, the pyrolytic cycle may not
start. Wait for the oven to cool down.
! The programme may only be started once the oven
door has been closed.
To activate the PYROLITIC CYCLE cleaning
procedure, press and hold the
approximately 4 seconds. The TIMER KNOB may be
used to select the desired cleaning level; there are
three default time settings which cannot be
modified.
1. Economy (ECO): turn the knob towards "-".
Duration 1 hour.
2. Normal (NOR): initial level. Duration 1 hour and 30
minutes.
3. Intensive (INT): turn the knob towards "+".
Duration 2 hours.
4. Press the button to confirm.
An end time for the PYROLITIC CYCLE (as for a
normal cooking cycle) may be programmed (see
Programming the automatic cleaning end time ).
36
Safety devices
• The
• The
• If a malfunction occurs, the heating elements will
• Once the oven door has been locked, you cannot
Programming the automatic cleaning end time
1. Press the
digits on the DISPLAY begin to flash.
2. Turn the TIMER KNOB towards "+" and "-" to
adjust the hour value.
3. Press the
digits on the DISPLAY begin to flash.
4. Turn the TIMER KNOB towards "+" and "-" to
adjust the minute value.
5. Press the
6. When the set time has elapsed, the text END
appears on the display and a buzzer sounds.
• For example: it is 9:00 a.m. and the Economy
button for
Programming has been set when the
buttons are illuminated. The DISPLAY shows the
PYROLITIC CYCLE end time and duration
alternately.
Once the automatic cleaning cycle is over
You will have to wait until the temperature inside the
oven has cooled down sufficiently before you can
open the oven door. You will notice some white dust
deposits on the bottom and the sides of your oven;
remove these deposits with a damp sponge once
the oven has cooled down completely. Alternatively,
you can make use of the already heated oven, in
which case it is not necessary to remove the
deposits, they are completely harmless and will not
affect your food in any way.
icon on the display, when lit, indicates
that the oven door was automatically locked as
soon as the temperature reached a high value.
icon indicates that the cleaning cycle
may be cancelled at any time by pressing the
button.
be switched off.
change the duration and cycle end time settings.
button until the
button again until the other two
button again to confirm;
PYROLYTIC cycle has been selected: default set
time 1 hour. 12:30 is scheduled as the end time.
The programme will start automatically at 11:30
a.m.
icon and the two
and