Atag WS90292FM Mode D'emploi page 37

USE
4. Press the On/Off button and the plus (+) button at the same time to confirm the chosen
setting.
The cooker hood automatically switches on at the chosen exhaust setting for 5 minutes
▷
every hour. The Clean Air indication flashes while the exhaust is active.
When the hood stops after 5 minutes, the Clean Air indication continues to be lit until
▷
the hood switches on again after 55 minutes.
5. Press any button (except the lighting button) to switch off the Clean Air function at any time.
Grease filter indicator
After 100 operating hours, the grease filter indicator will light up (see indication table).
1. Clean the grease filter.
2. While the hood is switched off, press the On/Off button twice.
There will be a long audio signal and the filter indicator is reset.
▷
The filter indicator automatically resets after 20 hours if a manual reset is not done.
▷
Carbon filter indicator
When the ventilation hood is used as a recirculation hood, a carbon filter must be installed.
In this case, activate the carbon filter indicator:
1. While the hood is switched off, press the minus (-) and plus (+) buttons at the same time for
5 seconds.
The carbon filter indicator appears in the display and an audio signal sounds.
▷
The operating time is reset (reset to zero).
▷
The carbon filter indicator will light up after 350 operating hours (see indication table).
1. Clean or replace the carbon filter.
2. While the hood is switched off, press the On/Off button twice.
There will be a long audio signal and the filter indicator is reset.
▷
The filter indicator automatically resets after 20 hours if a manual reset is not done.
▷
While the hood is switched off, press the minus (-) button for at least 4 seconds to check what
filter indications are active:
Indication in display Meaning
Clean grease filter
Replace carbon filter
EN 7