Length And Angle Adjustment Of The Footrest; Adjusting Seat Height (Rear Wheel Mount); Adjusting Seat Height (Front Wheel Mount); Adjusting The Positive Caster Of The Front Wheels - DeVilbiss Healthcare drive LITEC 2G PLUS Mode D'emploi

4
Never swivel the footrests inwards!
Length and angle adjustment
of the footrest
Length adjustment
(photo 6)
Loosen and remove the
screw at the back of the
footrest (see circle) and
adjust the length accordin-
gly as desired by pushing
up or down. Check where
the threaded hole is and
reinsert the locking screw.
Retighten the screw!
Angle adjustment
(photo 7)
Use the enclosed Allen
wrench to release the
screw on the footrest until
it can be pulled out of the
toothed wheel inwards.
Now rotate the footrest
into the desired position
and press it back into the
toothed wheel.
Retighten the screw!

Adjusting seat height (rear wheel mount)

The height of the seat at
the rear can be adjusted
in increments. To adjust
it, remove both hand rim
wheels by pressing the re-
lease button (see section
"Attach wheels"). Unscrew
the nut of the wheel mount
and move it into the desi-
red hole.
Replace the nut with the
locking washer and tigh-
ten it (photo 8).
Ensure that the wheel axle is properly tightened!
Drive Medical GmbH & Co. KG | As per: 24.06.2020 | Errors and alterations excepted
5
6
7
8

Adjusting seat height (front wheel mount)

The height of the seat can
be adjusted in increments
and is correspondingly ad-
justed in the desired incli-
nation of the seat surface.
To adjust, unscrew the
wheel axle screw and pull
it out.
The plugs of the corres-
ponding holes can be ea-
sily exchanged. Now move
the wheel in the desired
position and reinsert the wheel axle screw and tighten
it (photo 9).
Ensure that the wheel axle is properly tightened!
Adjusting the positive caster
of the front wheels
After the seat height is changed, the positive caster of
the front wheels must be readjusted.
To do this, loosen both
screws on the front wheel
fork to adjust the angle of
the negative or positive
caster of the front wheels
(photo 10).
After adjustment, screws must be tightened and che-
cked to ensure that they are securely held!
Instructions for use LITEC 2G PLUS
EN
9
10
17