Overlay Drawer Panel Installation - Marvel ML24RDS3 Série Instructions D'installation, D'utilisation Et D'entretien

Masquer les pouces

Table des Matières

Les langues disponibles

CAUTION

It is important to use the factory provided grille that came

with the product to assure proper air flow is maintained

through the condenser. The use of a custom grille is not

recommended and will void the warranty.

Full Overlay Panel Installation Instructions

Determine Wood Screw Requirements

1. A #10 pan head wood screw should be used to proper-

ly secure the overlay panel (See Figure 16). A quantity

of 16 screws are supplied with the unit in the literature

pack.

2. Use only pan head screws.

3. If your overlay panel is thinner than

you will need to purchase shorter screws. The longer

screws will break through the front of the panel.

Step 1: Remove Drawers from unit.

1. Begin by pulling out the top drawer. (See Figure 13).

Remove screws securing drawer to slides (See Figure

14). Pull drawer forward, lift up and out to clear clips in

rear of drawer. Move drawer forward about 1" (2.5 cm)

and set down on slides. At the right rear corner of the

drawer disconnect the display wire harness (See Figure

13a). Remove the drawer from the unit by lifting up off

of the slides. Repeat for bottom drawer but disregard

the harness instructions as there is no wiring to the bot-

tom drawer.

2. Remove the drawer divider from the top drawer and the

gasket from the drawer front. (See Figure 14). Do this

by pulling the gasket out of the channel that holds it to

the drawer front. This will expose the clearance holes

for mounting the overlay panel. (See Figure 18).