Marvel ML24RDS3 Série Instructions D'installation, D'utilisation Et D'entretien page 15

.35/.31
(9 mm/7.5 mm)
Step 2: Size the Overlay Panel
Cut the overlay panel to the dimensions shown below in
Figure 17. On the top drawer only drill the 2 counter-bored
holes which are clearance for screw heads on the face of
the top drawer.
This is also a convenient time to locate and drill the holes
for your handle. Most often the handle is to match that of
the surrounding cabinetry. If your handle attaches from the
back-side of the custom panel, locate the mounting holes
while the panel is attached to the drawer and cabinet. After
the panel is removed from the drawer, drill the mounting
holes from the front, to the recommended diameter of the
handle manufacturer. Counter bore the back-side of the
panel so the screw heads do not interfere with the surface
of the drawer.
Panel thickness
2 ⁄ "
3
8
(60 mm)
14 ⁄ "
29
32
(379 mm)
(This side facing interior)
OVERLAY DRAWER PANEL INSTALLATION
Figure 16
.50
(12.5)
23 ⁄ "
3
4
(603 mm)
1 ⁄ " (30 mm)
3
16
19"
(483 mm)
1"(25 mm) diameter counter
bore ⁄ " (6 mm) deep
1
4
2 places, top drawer only.
Figure 17
Face of
Overlay Panel
Figure 18
Step 3: Attach the Overlay Panel to the Drawer
1. Set the overlay panel on drawer front face and align
edges. (See Figure 18). The custom overlay panel
should be flush with the top of the drawer and centered
on the width of the drawer. Clamp panel in position and
mark pilot hole locations. Pick the required pilot hole
size from "Table A" below and drill the pilot holes ensur-
ing not to drill all the way through the overlay panel.
Table A: Pilot Hole Drill Sizes for Wood Screws
Material Type
Hardwood
Softwood
2. Insert wood screws through clearance holes and
tighten to secure overlay panel.
3. Reinstall gasket into channel. Make sure the corners
are fully inserted.
4. Place the drawer divider back into the top drawer.
Step 4: Reinstall the Drawers
1. Fully extend drawer slides and place drawer on slides.
Be sure that drawer sits evenly on both slides and clips
slide into place in rear of drawer.
2. Re-install wire harness at rear corner of top drawer.
3. Re-install two screws through drawer into slides.
15
#8 Wood Screw
⁄ Diameter Pilot Hole
1
8
⁄ Diameter Pilot Hole
7
64
Screw clearance
hole through
gasket extrusion
Figure 18a
Overlay panel
flush with top
edge of drawer
Custom overlay
panel to be cen-
tered on width of
drawer.
Using clearance holes in
gasket channel mark
hole locations onto panel