Full Overlay Panel Installation Instructions - Marvel 6RDE Instructions D'utilisation Et D'entretien

FULL OVERLAY PANEL INSTALLATION INSTRUCTIONS

Full Overlay Panel Installation Instructions
Determine Wood Screw Requirements
1. A #10 pan head wood screw should be used to proper-
ly secure the overlay panel (See Figure 11). A quantity
of 16 screws are supplied with unit.
2. Use only pan head screws.
3. If your overlay panel is thinner than
you will need to purchase shorter screws. The longer
screws will break through the front of the panel.
Step 1: Remove Drawers from unit.
1. Begin by pulling out the drawer. (See Figure 8). Re-
move screws securing drawer to slides. Pull drawer
forward, lift up and out to clear clips in rear of drawer.
(See Figures 9 and 10).
2. Remove the gasket from the drawer front. (See Figure
10). Do this by pulling the gasket out of the channel
that holds it to the drawer front. This will expose the
clearance holes for mounting the overlay panel. (See
Figure 13).
All manuals and user guides at all-guides.com
⁄ " (15.9 mm)
5
8
Figure 8
Figure 9
Remove screws
Clips
.35/.31
(9mm/7.5mm)
13
Gasket
Figure 10
.50
(12.5)
Figure 11