Noise Level; General Safety Regulations; Safety Notes; Safety Decals - breviglieri mekfold 300-500 Manuel D'utilisation Et D'entretien

macchine agricole
▪
Driveline
▪
Operation and maintenance manual for the machine
▪
«CE» declaration of conformity

1.5 NOISE LEVEL

The noise level (overhead noise) has been measured in compliance with the current laws, with the following results:
▪
Acoustic pressure LpAm (A) .................................................................................................................................. dB 83
▪
Acoustic power LwA (A) ........................................................................................................................................ dB 106,25
The operator is advised to wear adequate ear muffs as personal protective equipment to prevent damage to his hearing during
SECTION 2

General safety regulations

2.1 SAFETY NOTES

The user must inform his personnel about the risks deriving from accidents, about the safety devices installed to safeguard the
operator and about the general accident-preventing regulations established by the Directives and by the laws in force in the country
where the machine is used. It is therefore essential for operators to carefully read this manual, particularly the safety notes, and
to pay great attention to operations which could be particularly hazardous.
The Manufacturer declines all and every liability for failure to comply with the safety and prevention regulations given in
this manual.
Pay attention to this symbol when it appears in the manual. It indicates a possible danger situation.
There are three danger levels:
▪
DANGER: This is the maximum level danger signal and warns that unless the described operations are carried out
correctly, they will cause serious injuries, death or long term health hazards.
▪
WARNING: The «WARNING» signal warns that unless the described operations are carried out correctly, they could cause
serious injuries, death or long term health hazards.
▪
CAUTION: This sign warns that unless the described operations are carried out correctly, they could cause damage to the
machine and/or persons.

2.2 SAFETY DECALS

The machine has been designed and built in compliance with all possible safety standards able to safeguard those who work with
it. Despite this, there may still be residue hazards which are signalled on the machine by decals. These decals (pictograms) are
affixed to the machine and indicate the various situations of insecurity and danger in a brief form.
Keep the decals clean and immediately replace them if they detach or become damaged.
Carefully read the following descriptions and memorize the meanings of the safety decals.
mekfold 300
CAUTION
daily work with the machine.
- 24 -