Attachments; Supported Weight (Load) - IKA KS 130 basic Mode D'emploi

Attachments

Attachments recommended by IKA
tion table to ensure safe and secure operation. in addition , the usable
weight and speed ranges shown in the diagrams (hatched areas) must
not be exceeded.
AS 130.1 Universal attachment
Universal, steplessly adjustable clamping cylinders make it posible to
adjust to any container shape.
The universal attachment consists of:
AS 1.30 basic suspension
AS 1.5 fastening screw
AS 1.31 clamping cylinder
ATTENTION: The base suspension of the universal attachment is
secured in place by four lateral clamping screwson the agitation table.
AS 130.2 Holding bracket adapter
With additional holding brackets (AS2.1, AS2.2, AS2.3, AS2.4 and
AS2.5) the holding bracket adapter is suitable foe working with round
flasks, measuring flasks and Erlenmeyer flasks.
Recommended / maximum fitting
AS 2.1 Holding bracket
AS 2.2 Holding bracket
AS 2.3 Holding bracket
AS 2.4 Holding bracket
AS 2.5 Holding bracket
ATTENTION! The holding bracket adapter is secured in place by four
lateral clamping screws on the agitation table.
AS 130.3 Dish attachment
For gentle agitation at low speed, for example for Petri dishes or
culture flasks. The dish attachments is equipped with an anti-slip
sheet that prevents the dish from moving around during the agitation
process.
28
® must be connected to the agita-
1x Dimension WxHxD
4x in mm
3x 260 x 90 x 235
12 / 12 Dimension WxHxD
8 / 9 in mm
5 / 8 230 x 24 x 235
4 / 4
2 / 4
Dimension WxHxD
in mm
420 x 33 x 270
ATTENTION! The dish attachment is secured in place by four lateral
clamping screws on the agitation table.
AS 130.4 Reactant glass adapter
For intensive agitation of tubes, reactent bottles, cuvettes and centri-
fuge tubes. Clamping range from ø10mm to ø16mm for a maximum
of 64 tubes.
ATTENTION! The reactent glass adapter is secured in place by four
lateral clamping screws on the agitation table.
After vessels with a large diameter have been agitated for a long time
and the equipment is readjusted for vessels with a smaller diameter,
the clamping straps must be bent back carefully to ensure that they
clamp securely.

Supported weight (load)

In order to ensure safe and secure operation, the agitator must only be
operated within the range of usable weight and speed (see diagram -
hatched area). Please make certain that the holding surface on which
the agitator is placed is clean and level. Otherwise the working range
shown in the diagram (the hatched area) cannot be used.
If the agitator is screwed together with an adjacent piece of equipment
(i.e. if it is integrated into a system) it should be noted during opera-
tion that dynamic forces may arise as a result of unfavorable loading
circumstances and the position of the center of gravity. This may cause
the adjacent equipment to vibrate or may cause the table to vibrate
uncontrollably. If you notice that the device is running unevenly, the
speed must in any case be reduced until the running irregularities no
longer occur.
Make certain that individual agitation vessels are placed in the middle
of the agitation table and multiple agitation vessels are place evenly on
the agitation table, and that all vessels are securely fastened in place.
Dimension WxHxD
in mm
228 x 95 x 234