Epa Energy Star Compliance; Power Cord Set Requirements - HP FS7600 Manuel De L'utilisateur

EPA Energy Star Compliance

Monitors that are marked with the Energy Star
meet the requirements of the EPA Energy Star program.
As an Energy Star Partner, Hewlett-Packard Company
has determined that this product meets the Energy Star
guidelines for energy efficiency. Specific details on
using the Energy Saving features can be found in the
energy saver or power management section of the
computer manual.

Power Cord Set Requirements

The monitor power supply is provided with Automatic
Line Switching (ALS). This feature allows the monitor
to operate on input voltages between 100–120V
or 200–240V .
The power cord set (flexible cord or wall plug) received
with the monitor meets the requirements for use in the
country where you purchased the equipment.
If you need to obtain a power cord for a different
country, you should purchase a power cord that is
approved for use in that country.
Filename: sa517093.doc Title: User's Guide
Template: Print_2004.dot Author: WASSER Studios
Revision #: 36 Page: 15 of 20 Printed: 12/01/04 12:35 PM
The power cord must be rated for the product and
for the voltage and current marked on the product's
®
Logo
electrical ratings label. The voltage and current rating
of the cord should be greater than the voltage and
current rating marked on the product. In addition, the
cross-sectional area of the wire must be a minimum of
0.75 mm² or 18AWG, and the length of the cord must
be between 4.94 feet (1.5 m) and 12 feet (3.6 m).
If you have questions about the type of power cord to
use, contact your HP authorized service provider.
A power cord should be routed so that it is not likely to
be walked on or pinched by items placed upon it
or against it. Particular attention should be paid to the
plug, electrical outlet, and the point where the cord
exits from the product.
Last Saved By: billm
15
User's Guide