Marmitek MegaView50 Guide Utilisateur page 5

3. C onnect the MegaView50/51 receiver (Audio/Video Receiver) to your display device
[2] (for instance TV or projector) using a cinch cable (not included).
Please make sure that the colours of the plugs correspond to the input sockets. That
means red to red, white to white and yellow to yellow.
4. U se a CAT5 Ethernet cable (not included) to connect the MegaView50/51 transmitter
and receiver to each other [3].
INSTALLATION IR (INFRARED) RETURN (MEGAVIEW51 only)
1. P osition the MegaView51 transmitter at an accessible location behind or next to
your A/V devices and close to a wall socket. Please take into account the cable
length of the IR LEDs and make sure that the connections remain accessible.
2. P lug the required IR Extender cable (with the 2 IR LEDs) [4] into the MegaView51
transmitter.
• Self-adhesive foil has been supplied with the IR LEDs. This allows you to attach the
IR LEDs to the IR sensor of your A/V device.
• Test the position and operation of the IR LEDs before sticking them definitively to
the IR sensor of your A/V device.
• In case you want to operate another device besides your A/V device (of which you
are transmitting the signal), you may use the second IR LED for this.
• If you are only using one of the two IR LEDs, please leave the second IR LED
unused. Never remove it from the extender cable!
3. Now connect the IR Receiver [5] to the MegaView51 receiver.
• Position the supplied IR receiver in sight of your infrared remote control and as
little as possible in the proximity of potential sources of interference such as direct
sunlight, strip light, energy saving bulbs, etc. The infrared indicator LED in the IR
receiver will light up or blink when it receives infrared communication. Use this
indicator LED to position the IR receiver at the most interference-free location
(indicator LED will not or hardly light up when it does not receive a signal).
• By using the supplied self-adhesive strip, placement is possible almost everywhere.
Please experiment with the right positioning before definite attachment of the IR
receiver.
• Attention! The adhesive strip may cause discolouration on certain surfaces or
leave behind traces of glue.
4. C onnect the power adapter [6] to the "POWER" socket of the MegaView51 receiver
and plug the adapter into a wall socket.
Megaview50 & 51 5