Random Orbit Sander Operation - Metabo SV 13YST Instructions De Sécurité Et Mode D'emploi

RANDOM ORBIT SANDER OPERATION

WARNING:
1. How to hold the random orbit sander
While gripping the housing, lightly press
the sander against the surface to be
sanded so that the sanding paper uniformly
contacts the surface, as shown in Fig. 6.
DO NOT apply excessive pressure to the
sander while sanding. Excessive pressure
may cause overload of the motor, reduced
service life of the sanding paper, and
lowered sanding or polishing effi ciency.
2. How to move the random orbit sander
Move the sander by either moving it up
and down or by moving it in circles while
gradually progressing in a sideways
direction. (Figs. 7 and 8)
3. Switching the sander ON and OFF
The power can be turned on by setting the
switch to ON (I) and turned off by setting
the switch to OFF (O).
NOTE:
Never turn the power switch ON when
the sander is contacting the surface to
be sanded. This is necessary to preclude
damage to the material. The same applies
when switching the power OFF.
CAUTION:
● lmmediately after use, always turn the
sander off and unplug it.
● Since the sander may suck in dust and
debris, be careful not to place it where
there is much dust and debris when it
is still spinning right after use.
● Looking from above, the sanding pad rotates clockwise during the loaded operation,
but it may rotate counterclockwise during the no-load operation.
● Never run the tool without the sanding paper. You may seriously damage the support
plate.
● Using the tool with the support plate edge contacting the workpiece may damage
the support plate.
Never apply water or grinding fl uid when sanding. This could result
in electrical shock.
English
Fig. 6
Fig. 7
Fig. 8
11