Moon Phases; Frost Alarm; Temperature Alarm; Charging Function - Hama Premium HX075-0501200-AG-001 Mode D'emploi

6.8 Moon phases

The base station displays the current moon phase (A5) using
the following symbols:
Display (A5)

6.9 Temperature alarm

Setting the upper/lower temperature limit
Note
• You can define a lower and an upper limit value and
activate an alarm for each channel and/or connected
measuring station.
• Note that the lower limit value must be at least 1°C/1°F
below the upper limit value.
• Press and hold the " " button (B6) for approximately 2
seconds.
• The symbol for the upper temperature limit alarm "
flashing. Use the " " (B4) and " " (B5) buttons to set the
desired maximum temperature. Press the " " button (B6)
again to confirm your settings.
• Then the symbol for the lower temperature limit alarm
" " starts flashing. Repeat the procedure for the lower
limit.
Moon phase
New moon
Waxing crescent
Half-full
Waxing gibbous
Full moon
Waning gibbous
Half-full
Waning crescent
" starts
Enabling the temperature alarm
• Press the " " button (B6) to enable/disable the temperature
alarm. When the temperature warning is active, the
temperature/frost alarm symbol (A3) is displayed.
• Once the upper or lower limit of the temperature range is
reached, an alarm signal sounds. The "ALERTS" display and
the temperature display (A3) begin flashing.
• Press any button to stop the warning signal.
• If the temperature exceeds the value of the set upper limit, "
" also starts flashing in the display.
• If the temperature goes below the value of the set lower
limit, " " also starts flashing in the display.
• Press the " " button (B6) to end the warning indicators in
the display.

6.10 Frost alarm

Note
The frost alarm is automatically enabled when the
temperature alarm is enabled.
• If the outdoor temperature is measured to be within the
range of –1 to 3 °C, the ice symbol (A3) is shown in the
display.

6.11 Charging function

Warning – Connecting terminal devices
• Before connecting a terminal device, check whether the
power output of the charger can supply sufficient power
for the device.
• Ensure that the power of the connected terminal device
does not exceed 5 W.
• Please refer to the operating instructions for your terminal
device.
Note
The charging function is only possible when plugged into
mains power.
• Connect your terminal device to the USB charging socket of
the weather station (B11) using a suitable USB cable.
• The charging progress is displayed on your terminal device.
• Disconnect the terminal device from the USB charging socket
if you want to interrupt charging or if the terminal device is
fully charged.

6.12 Backlight

• Press the " / " button (B1) to light up the display.
• During battery operation, the display is illuminated for
approximately 15 seconds.
7