Base Station; Measuring Station - Hama Premium HX075-0501200-AG-001 Mode D'emploi

5. Installation
Note – Installation
• We recommend initially placing the base and measuring
stations in the intended locations without installing them
and making all the settings described in 6. Operation –
to do.
• Only install the stations once the appropriate settings have
been made and a stable wireless connection is established.
Note
• The wireless transmission range between the measuring
and base stations is up to 50 m in open spaces.
• Before installation, ensure that wireless transmission will
not be disrupted by interference or obstacles like buildings,
trees, vehicles, high-voltage lines, etc.
• Before the final installation, ensure that there is sufficient
reception between the intended installation locations.
• When installing the measuring station, ensure that it is
protected from direct sunlight and rain.
• The international standard height for measuring air
temperature is 1.25 m (4 ft) above ground.
Warning
• Buy special or suitable installation material from a
specialised dealer for wall-mounting.
• Ensure that no faulty or damaged parts are installed.
• Never apply force during installation. This could damage
the product.
• Before installation, ensure that the chosen wall is suitable
for the weight to be mounted, and make sure that there
are no electrical wires, water, gas or other lines at the
installation site on the wall.
• Do not mount the product above locations where persons
might linger.

5.1 Base station

• Use the base to position the base station on a level surface.
• Alternatively, you can install the base station on a wall using
the opening (B13) on the back.

5.2 Measuring station

• You can also position the measuring station on a level
outdoor surface.
• We recommend installing the measuring station securely on
an outdoor wall (C6).
• Install an anchor, screw, nail, etc. in the wall of your choice.
• Hang up the base/measuring station using the opening
(B13/C6) intended for this purpose.
4
6. Operation
Note – Input
• Hold the button (B4) or the
values faster.
6.1 Connection to the measuring station
• After you insert the batteries, the base station automatically
searches for a connection to the measuring station and
performs initial setup.
Note
• Initial setup takes approximately 3 minutes.
• During the connection attempt, the radio symbol on the
measuring station (A12) will flash.
• Do not press any buttons during setup. Otherwise, values
may not be transmitted correctly and there is a risk of
value errors and inaccuracies.
• The setup process is completed when the indoor and
outdoor measurement data (A1/A2/A8/A10) is displayed.
• If the base station still does not receive a signal from the
measuring station, press and hold the
approx. 3 seconds to start the manual search for the signal.
Note – Faulty transfer of measured values
• In isolated cases, interference - e.g. from a WLAN network,
a computer or a television set - can cause the transfer of
measured values between the measuring station and the
base station to fail.
• In this case, you must resynchronise the stations by briefly
removing the batteries from both stations and reinserting
them.
• If the measured values are not transferred again once the
batteries are inserted, replace the batteries with new ones.
• If necessary, select a new location for the base station in
order to avoid possible interference in the future.
6.2 Selecting the channel/other measuring stations
Note
You can install two more measuring stations in addition to
the included measuring station. Ensure that the base and
measuring stations are set to the same channel.
• Press the button (B5) repeatedly to set the channel to that
set on the respective measuring station. Channel 1, 2 or 3
is displayed.
• If the symbol is displayed, the weather station will
automatically switch the displayed channel every five
seconds.
button (B5) to select the
button (B5) for