Care And Maintenance - Hama TS34A Mode D'emploi

Note
• The setup process is completed when the indoor and outdoor
measurement data is displayed on the base station.
• The measured value is automatically updated by the base device about
every 57 seconds.
6.2. Selecting the channel/Other measuring stations
Note
• Ensure that the base station and measuring station are set to the same
channel. Suitable base stations can be found at www.hama.com
• The transmission channel on the supplied measuring station can be
changed/set (CH1, CH2, CH3).
• The measuring station is suitable for the following base stations: 76045,
113964, 123126, 123127,123128, 123129, 136256, 136257, 136258,
136259, 186306, 186307, 186308; 186353, 186354, 186417, 186418
6.3. Low battery charge
Note – Replacing the batteries
• Note that the stations have to be resynchronised each time after you
change the batteries in the measuring or base station.
• To do this, remove the batteries from the other station and then reinsert
them, or change them as required.

7. Care and Maintenance

• Only clean this product with a slightly damp, lint-free cloth and do not use
aggressive cleaning agents.
• Make sure that water does not get into the product.
7