Controls And Displays - Hama Milano Mode D'emploi

G Operating instruction

Controls and Displays

1. Thermometer
2. Barometer
3. Hygrometer
4. Screwdriver
Thank you for choosing a Hama product.
Take your time and read the following instructions
and information completely. Please keep these
instructions in a safe place for future reference. If
you sell the device, please pass these operating
instructions on to the new owner.
1. Package Contents
• 1 "Milano" outdoor weather station
• 1 screw for assembly
• 1 screwdriver
• 1 wall anchor
• These operating instructions
2. Safety Notes
• The product is intended for private, non-
commercial use only.
• Do not use the product in the immediate vicinity of
heaters or other heat sources or in direct sunlight.
• BDo not operate the product outside the power
limits given in the specifications.
• Do not drop the product and do not expose it to
any major shocks.
• Dispose of packaging material immediately
according to locally applicable regulations.
• Do not modify the product in any way. Doing so
voids the warranty.
2
3. Installation
Note
• Set the weather station correctly before
installing it.
• When installing the weather station, ensure
that it is protected from direct sunlight and
rain.
• The international standard height for measuring
air temperature is 1.25 m
• (4 ft) above ground.
Warning
• Buy special or suitable installation material
from a specialised dealer for wall-mounting.
• If the product is attached to an object or
building, it must be fastened properly and
securely; it may not be stuck on with glue.
• Ensure that no faulty or damaged parts are
installed.
• Before installation, ensure that the chosen wall
is suitable for the weight to be installed, and
make sure that there are no electrical wires,
water, gas or other lines at the installation site
on the wall.
• Alternatively, install anchors, screws, nails, etc. in
the wall of your choice.
• Hang up the weather station using the opening
intended for this purpose.