Replacing The Blade; Disposal And Recycling; Ordering Replacement Parts - EINHELL BG-CM 24 Mode D'emploi

Anleitung_BG_CM_24_SPK7:_
blade and make sure that it is tightly fastened. If
the blade is completely worn out, it must be
immediately replaced or ground sharp again. An
excessively vibrating mower means that the
blade is not properly balanced or has become
deformed from striking an object. In this case,
the blade must be repaired or replaced.
There are no parts inside the equipment which
require additional maintenance.

7.4 Replacing the blade

For safety reasons, we recommend having the blade
replaced by an authorized professional. Important.
Wear work gloves! Only replace the blade with a
genuine Einhell replacement blade, as this will ensure
top performance and safety under all conditions.
Carry out the following steps to change the blade:
Undo the fastening screw (Fig. 7a/Item T).
Remove the blade and replace with a new one.
When fitting the blade, make sure it is installed in
the right direction. The blade's air vanes must jut
into the motor compartment (see Fig. 7a). Make
sure to fit the fastening elements in the correct
order (Fig. 7b): Spacer sleeve (O), fan impeller
(P), blade (Q), plastic washer (R), metal washer
(S), fastening screw (T). Ensure that the metal
washer (Fig. 7c/Item S) is correctly positioned on
the axle.
Then retighten the fastening screw with the
universal wrench. The tightening torque should
be approx. 25 Nm.
At the end of the season, perform a general
inspection of the lawn mower and remove any grass
and dirt which may have accumulated. At the start of
each season, ensure that you check the condition of
the blade. If repairs are necessary, please contact our
customer service center. Use only genuine spare
parts.

7.5 Ordering replacement parts:

Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
Replacement blade art. no. 34.054.70
12.02.2009 14:10 Uhr Seite 17

8. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
GB
17