Roller Grill SEM 800 PDS Notice D'installation Et D'utilisation page 17

c) Use of device :
Elements of command and display
Command/Display
PDS commutator (n°1 on
picture)
Energy regulator (n°2 on
picture)
Orange pilot light (n°3 on
picture)
Green pilot light (n°4 on
picture)
Commutator 4 positions (n°5
on picture
Stop
Start
Putting on
Turn on the commutator control knob (n°5 on picture) on wished position accord-
ing to desired cooking zone to be used and the energy regulator (n°2 on picture)
on wished power.
The pilot lights (n°3 and 4 on picture) ignite.
To use the plate detection system (PDS), set the commutator (n°1 on picture) on
Start position and the energy regulator on position C.
The cooking with infrared radiation does not need preheating.
Stopping the appliance
Set the commutator control knob, the PDS commutator and the energy regulator
on 0
Disconnect the power cable.
Let the device cool down
Clean the appliance. (see 6. Cleaning)
Function
Plate detection system on/off
Regulate the heating power
Heating up (pilot light on)
On/off for each cooking area (pilot light on)
Cooking area selection
Stop
Continuous
Start
Stop
Left
area
Right area
All
Areas
17