Transport And Storage - Hilti TE 2-A22 Mode D'emploi

• Avoid ingress of moisture.
Maintenance
• Check all visible parts and controls for signs of damage at regular intervals and make sure that they all
function correctly.
• Do not operate the product if signs of damage are found or if parts malfunction. Have it repaired
immediately by Hilti Service.
• After cleaning and maintenance, fit all guards or protective devices and check that they function correctly.
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by Hilti for use with the product can be found at your
local Hilti Store or online at: www.hilti.group.
6.2 Cleaning the dust shield
▶ Clean the dust shield on the chuck with a dry, clean cloth at regular intervals.
▶ Clean the sealing lip by wiping it carefully and then grease it again lightly with Hilti grease.
▶ It is essential that the dust shield is replaced if the sealing lip is damaged.
7

Transport and storage

7.1 Transport and storage of cordless tools
Transport
CAUTION
Accidental starting during transport !
▶ Always transport your products with the batteries removed!
▶ Remove the battery.
▶ Never transport batteries in bulk form (loose, unprotected).
▶ Check the tool and batteries for damage before use after long periods of transport.
Storage
CAUTION
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the tool and batteries in a place that is as cool and dry as possible.
▶ Never store batteries in direct sunlight, on heating units or behind a window pane.
▶ Store the tool and batteries in a place where they cannot be accessed by children or unauthorized
persons.
▶ Check the tool and batteries for damage before use after long periods of storage.
8 Troubleshooting
8.1 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
8.2 The rotary hammer is not in working order
Trouble or fault
The rotary hammer doesn't
start.
The LEDs indicate nothing.
8 English
Possible cause
The rotary hammer has been over-
loaded.
The battery is not fully inserted.
The battery is discharged.
Action to be taken
▶ Switch off the rotary hammer,
remove the battery and do
not continue to use the rotary
hammer.
▶ Push the battery in until it
engages with a double click.
▶ Change the battery and charge
the empty battery.
2153711
*2153711*