Specific Safety Instructions; Instructions For Use; Placement Tool - stayer VENTO 2400 B Instructions D'emploi

The STAYER VENTO 2400 B / VENTO 2400 C electropor-
table blowing and aspiring machine may be used only for
aspiring together with a collector bag, and blowing dry plant
materials within the scope of domestic gardens. Any other
kind of use such as farming works, forestry o public use is
prohibited.
1. Contents
2.Specific safety instructions......................................14
3.Instructions for use....................................................14
3.1 Placement Tool.............................................................14
3.2 Assembly......................................................................14
3.3 Illustrated description............................................15
4.Operating instructions..............................................15
4.1 On / Off.................................................................15
4.2 Troubleshooting.................................................15
5.Maintenance and service instructions.....................16
5.1 Repair service.......................................................16
5.2 Warranty...............................................................16
5.3 Disposal and recycling..........................................16
6.Regulations................................................................16
6.1 Technical Data......................................................16
6.2 EU declaration of conformity.................................17

2. Specific safety instructions

BEFORE USE
• Be familiar with the controls and the proper use of the
tool.
• Check the functioning of the tool before each use and,
in case of a defect, have it repaired immediately by a
qualified person; never open the tool yourself.
• Before use, thoroughly inspect the area where the tool
is to be used and remove all solid objects that could
damage the shredding mechanism when vacuuming
(such as stones, broken glass, pieces of metal).
• When vacuuming, never use the tool without the
collection bag in place.
• Regularly check the collection bag for wear or
damage.
• Replace worn of damaged parts
• Keep all nuts, bolts and screws tight to be sure that
the tool is in a safe working condition
DURING USE
• Always keep the cord away from moving parts of the tool;
direct the cord to the rear, away from the tool.
• Operate the tool at a walking pace only (do not run).
• Keep proper footing on slopes.
ENGLISH
14
• Always ensure that the ventilation openings are kept
clear of debris.
• Take a secure stance when working (do not overreach,
especially when using steps or a ladder)
EXPLANATION OF SYMBOLS ON TOOL
Read the instruction manual before use. Fig. 2
page
Wear protective glasses. Fig. 3
Do not expose tool to rain. Fig. 4
Pay attention to the risk of injury caused by flying debris
(keep bystanders a safe distance away from work area).
Fig. 5
S w i t c h o f f a n d d i s c o n n e c t p l u g b e f o r e
cleaning/maintenance or if (extension) cord is damaged or
entangled. Fig. 6
Double insulation (no earth wire required). Fig. 7

3.Instructions for use

3.1 Placement Tool

This tool has been designed for blowing/collecting as well
as vacuuming/shredding dry leaves and other dry garden
rubbish such as grass and twigs.
This tool is intended for domestic use only and is not
designed to be used under wet conditions.
This tool is not intended for professional use.
Read this instruction manual carefully before use and
save it for future reference (Fig.2).
Pay special attention to the safety instructions and
warnings; failure to follow these may result in serious
injury
Check whether the packaging contains all parts as
illustrated in drawing (Fig.1).
When parts are missing or damaged, please contact your
dealer
3.2 Assembly (Fig. 8)
Ensure that tubes 1 and 2 and collection bag 3 are
assembled correctly and that shoulder strap 4 is adjusted
correctly before operating the tool.
Firmly tighten all screws, bolts and nuts
For VENTO 2400 B
The machine is packaged with the telescopic air 1
channeling tube disassembled and folded. To couple the
tube 1 to the machine's motor set 15, first extend the tube 1
and then fix it to the motor set 15.
14