Fault Diagnosis - Truvox Orbis Battery Scrubber II Manuel D'utilisation


Defects in other than genuine Truvox parts, or
repairs, modifications or adjustments performed by
other than a Truvox service engineer or authorised
service agent.

Costs and risks of transport relating directly or
indirectly to the guarantee of this product.
RECOMMENDED SPARES & ACCESSORIES
Part No. Item
05-4621-0000 Standard brush (black)
05-4622-0000 Soft brush (white)
05-4620-0000 Drive board
95.0048.00 Squeegee front & rear blades PARA (1 pair of blades)
95.0049.00 Squeegee front & rear blades PARA (5 pairs of blades)
95.0050.00 Squeegee front & rear blades Anti-oil (1 pair of blades)
95.0051.00 Squeegee front & rear blades Anti-oil (5 pairs of blades)

FAULT DIAGNOSIS

The following simple checks may be performed by the operator. If the machine is still not working, please contact your local Service Agent:
Trouble
The machine does not start up
The brush does not rotate
Vacuum does not work or the
machine is leaving traces of water
No water comes out
Insufficient floor cleaning
* If the fuse blows several times, the machine should be checked by an authorised Service Agent.
PLEASE REFER TO THE BACK OF THE MANUAL FOR PICTORIAL INSTRUCTIONS
4
Reason

Batteries aren't connected.

Low battery.

Motor is not connected.

Can you hear the vacuum running?

Recovery tank is full.

Recovery tank drain hose plug is
not fitted correctly.

Recovery tank lid is not fitted
correctly.

Vacuum float cage is blocked or ball
is stuck.

Squeegee hose is damaged or not
fitted correctly.

Squeegee blades are not on the
floor

Squeegee blades are damaged or
dirty

Brush motor is not turned on

Solution tank is empty

Solution solenoid button is not
working

Water tap is in closed position

Unsuitable brush or detergent

Worn brush

Consumable items such as, brushes, drive discs, filters
and vacuum skirts.
This guarantee does not affect your statutory rights, or your
rights against the supplier arising from their sales or purchase
contract.Truvox International Limited policy is one of continual
product development and we reserve the right to alter
specifications without prior notice.
Usage
General purpose scrubbing
Light scrubbing
For use with pads
Wet pick up on all types of floor
Wet pick up on all types of floor
Oil resistant squeegee blades
Oil resistant squeegee blades
Remedy

Connect the batteries.

Charge the machine for 8 hours.

Connect the motor.

If yes, follow steps below. If no, contact your
local Service Agent.

Empty recovery tank.

Refit the recovery tank drain hose plug.

Refit the recovery tank lid.

Check vacuum float cage for debris and clean.
Check ball is not stuck in top position.

Check squeegee hose for signs of damage and
refit.

Use foot pedal to lower the squeegee blades to
the floor

Check squeegee blades for signs of damage and
clean.

Turn on brush motor

Fill solution tank

Check the solution solenoid button light comes
on and you can hear it when pulling the handle
triggers.

Change water tap to open position. The water
tap can be found at the back of the machine,
just inside of the left hand wheel from the
operator's position.

Use a brush and detergent which are suitable
for the type of floor or dirt to be cleaned.

Replace brush
12-18