Preparing The Appliance; Battery Charging - ohmex VVC 1322 Manuel D'utilisation

EN

PREPARING THE APPLIANCE

At the appliance first use, remove it from its packaging and make sure that all
of the components indicated in the previous pages of this manual are present.
If not, please refer to the retailer.
INSTALLATION OF THE BASE
Install the support base (9) on a stable wall making sure that there's a power
outlet nearby in order to be able to connect the battery charger.
The base (9) must be installed at such a height that the brush (11) is supported
by the ground.
- Stick the four supplied adhesives on the back of the support base (9).
- Remove the protective film of the adhesives; attach the base onto the wall.
- Make sure the base is stable and mounted correctly, then attach the handle (1) to the
base (9).
Make sure the appliance cannot detach and fall.

BATTERY CHARGING

Only use the charger supplied with the appliance. Do not charge
the appliance if the temperature is lower than 0°C or higher
than 40°C. Using an universal charger cancels the warranty.
- Before using the vacuum cleaner for the first time, the battery must be entirely charged
(approximately 5÷6 hours).
When the indicator (3) flashes in red, it means that the battery is low and that it
must be recharged.
- During charging, the appliance must be turned off.
- Position the motor body (4) next to a power outlet.
50
VVC 1322