Attaching The Blade; Attach The Adapter To The Power Supply Of The Charger - Aesculap DURATI Mode D'emploi

Aesculap Suhl GmbH
DURATI battery-powered shearing machine

4.1.2 Attaching the Blade

Risk of injury caused by sharp cut-
ting plates!
Handle the shearing head of the
DURATI shearing machine care-
WARNING
fully.
Note
The shearing head GT330 #10 for the DURATI battery-
powered shearing machine is included in the scope of
delivery. Various shearing heads are available for dif-
ferent applications!
17
Fig. 1
If knife hinge is closed: Open knife hinge 17 with
screwdriver, see Fig. 1.
12
Fig. 2
6
17
Install shearing head 12 on opened knife hinge 17,
see Fig. 2.
Press on/off switch 11.
Press shearing head 12 slightly in the direction of
the DURATI shearing machine, see Fig. 2.
The shearing head 12 engages audibly.
Check that the shearing head 12 is correctly seated
on the DURATI shearing machine.
4.1.3 Attach the adapter to the power sup-
ply of the charger
The adapter for EU countries is installed on the power
supply of the charger at the factory.
Note
The USA adapter is integrated into the power supply.
The USA adapter can be folded out if no other adapter
is installed on the power supply.
14
15
18
Fig. 3
Remove EU/UK/AUS from the power supply.
Loosen the fixation screw 18 in adapter 15, see
Fig. 3.
Press the lock release 16 and remove the
adapter 15 from the power supply.
Install the EU/UK/AUS adapter on the power supply
Push the adapter 15 onto the power supply 14
until the lock 16 clicks into place, see Fig. 3.
Screw the fixation screw 18 Screw the fixation
screw 15.
14
15