Aesculap Suhl GmbH
DURATI battery-powered shearing machine
If necessary, repeat the cleaning/disinfecting pro-
cess.
5.2 Control, care and inspection
Allow the product to cool down to room tempera-
ture.
Inspect the product after each cleaning and disin-
fecting cycle to be sure it is clean, functional and
undamaged.
Lubricate the shearing head as appropriate, see
Lubricating the shearing head.
Check the product for any damage, atypical run-
ning noise, overheating or excessive vibration.
Inspect the shearing head for broken, damaged or
blunt cutting edges.
Set aside the product if it is damaged.
7.
Troubleshooting
7.1 DURATI battery-powered shearing machine
Issue
The DURATI battery-pow-
ered
shearing
machine
does not start
DURATI
battery-powered
shearing
machine
has
come to a stop
DURATI
battery-powered
shearing machine does not
load into the charging sta-
tion
10
Detection
Check switch position
–
–
–
–
LED indicators do not
light up
6.
Maintenance
To ensure reliable operation, Aesculap recommends
servicing the product at least once a year.
Service addresses
Albert Kerbl GmbH
Felizenzell 9
84428 Buchbach / Germany
Phone:
+49 (0) 8086 933-100
Fax:
+49 (0) 8086 933-500
Email:
info@kerbl.com
www.kerbl.com
Other service addresses can be obtained from the
address indicated above.
Cause
Li-ion battery not loaded
Li-ion battery defect
Li-ion
battery
not
inserted
Li-ion battery deactivated
through protective circuit
Li-ion battery is empty
–
Remedy
Load Li-ion battery
Insert new Li-ion battery
Insert new Li-ion battery
Deactivate and reacti-
vate the control unit
Insert new Li-ion battery
see Charger and Li-ion
battery