Aesculap Suhl GmbH
DURATI battery-powered shearing machine
Insert the DURATI battery-powered shearing
machine 2 in charging bay 10 of the charger 4 and
charge the machine
Charge status indicator 8 or 9 blinks green.
After charging, the charge state indicator 8/9
lights up green and the DURATI battery-powered
shearing machine 2/with Li-ion battery 7 is ready
for operation.
The product is ready for operation.
4.4 Safe handling: Blade
4.4.1 Sharpening the cutting plate
Note
For sharpening the cutting plate, please contact Tech-
nical Service, see Technical Service.
4.4.2 Changing the shearing head
Risk of injury caused by sharp cut-
ting plates!
Handle the shearing head of the
WARNING
DURATI shearing machine care-
fully.
13
Fig. 4
Press ON/OFF switch 11 to switch off the DURATI
battery-powered shearing machine.
8
Press shearing head lock 13, see Fig. 4.
12
2
Fig. 5
Fold forward shearing head 12, see Fig. 5.
Detach shearing head 12.
Clean open knife hinge with a brush.
Install shearing head on knife hinge 12.
Press on/off switch 11.
Press shearing head 12 slightly in the direction of
the DURATI battery-powered shearing.
Shearing head 12 will audibly click into position.
Check that the shearing head 12 is correctly seated
on the DURATI battery-powered shearing machine.
4.4.3 Lubricating the shearing head
Clean upper cutting plate and lower cutting plate
with a soft wipe or brush. Make certain the gaps in
serration are cleaned properly.
Slightly lubricate upper cutting plate and lower
cutting plate with special lubricant for shearing
heads GT604.