Melitta bar mc-cw Mode D'emploi page 28

7. Preparation
After the device has been properly set up and
connected according to these instructions, you can
now prepare it for operation:
If cleaning is first required, refer to chapter 8
❍
for details.
If you have previously moved the device, let it
❍
stand still for 2 hours to allow the oil filling to
distribute itself uniformly.
When the warming feature is switched on, the
stainless steel bottoms become unpleasantly hot.
Do not touch them there is danger of burning.
GB
a) Filling the cup cabinet
Attention: The surface of the stainless steel bottoms
may become scratched. Therefore exercise care
when setting up and removing the cups and glasses.
Always place the cups and glasses with the
➂
opening down into the cup cabinet. This will
keep the heat in the vessels.
b) Refilling the milk
Use pre-cooled milk - the cooling power is designed
to keep items cool but not to cool down warm milk.
Open the device door and ...
➃
Pull out the milk container by approximately one
➄
third.
Push the cover back and fill the milk into the milk
➅
container.
When closing the cover, check to make sure that
➆
the milk suction hose is immersed in the milk.
You may now push the container in the
refrigerator and close the door.
c) Switching ON / OFF
The two ON/OFF switches are located behind the
opened door of the device. Use the ...
left switch to turn on the warming plates and
➀
the right switch to turn on the refrigerator.
➁
The device should be switched on approximately one
hour before use to allow the refrigerator to cool
sufficiently and the warming plates to heat up to
operating temperature.
Caution Hot!
➀
➂
➃ ➄
8
➁
➆
➅