Beamz 152.927 Notice D'utilisation page 6

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Important!
The manufacturer will not accept liability for any resulting damages caused by the
non-observance of this manual or any unauthorized modification to the device.
Please consider that damages caused by manual modifications to the devise are
not subject to warranty.
Never let the power-cord come into contact with other cables! Handle the
power-cord and all connections with the mains with particular caution!
Make sure that the available voltage is not higher than stated on the rear panel.
Always plug in the power plug least. Make sure that the power-switch is set to
off-position before you connect the device to the mains. The power-plug has to be
accessed after installing the device.
Make sure that the power-cord is never crimped or damaged by sharp edges.
Check the device and the power-cord from time to time.
Always disconnect from the mains, when the devise is not in use or before
cleaning it. Only handle the power-cord by the plug. Never pull out the plug by
tugging the power-cord.
It is essential to connect the yellow/green conductor to earth.
The electric connection, repairs and servicing must be carried out by a qualified
employee.
Do not switch the fixture on and off in short intervals as this would reduce the
laser diode life.
For replacement, please use fuses of same type and rating only.
If the device has been exposed to drastic temperature fluctuation, do not switch it
on immediately. The arising condensation water might damage your device.
Leave the device switched off until it has reached room temperature.
Do not shake the device. Avoid brute force when installing or operating the
device.
When choosing the installation-spot, please make sure that the device is not
exposed to extreme heat, moisture or dust. There should not be any cables lying
around. You endanger your own and the safety of others!
The minimum distance between the fixture and surrounding walls must be more
than 50cm.
Always fix the fixture with an appropriate safety-rope. Fix the safety-rope at the
safety-rope only.

Publicité

Table des Matières
loading

Table des Matières